Brake Light Switch, through 10.05.2005

Brake Light Switch, through 10.05.2005

Includes Brake Pedal Switch (F47).

On vehicles from CW 10.05.2005, brake light switch is located on brake master cylinder.

Brake Light Switch (F) must only be assembled once, otherwise locking mechanism of brake light switch will be damaged and a sufficiently secure seating is no longer guaranteed.





Brake light switch must be removed for adjustment.

- Remove trim on driver side..

Removing

- Disconnect connector from brake light switch.

- Remove brake light switch by rotating 45° toward left.

Installing and Adjusting

In order to assure sufficiently secure fitting, brake light switch must not be installed more than once.

Before installing brake light switch, grease plunger head with Polycarbamide grease (G 052 142 A2).

- Before installing, remove plunger completely

- Guide switch through assembly hole, press against the pedal and secure by rotating 45° toward right.





- Brake pedal remains always in rest position (not operated) while doing so.

- Connect brake light switch connector.

- Check function of brake light.

After adjusting the brake light switch check whether the brake pedal is on the end stop (rest position).

- Install trim on driver side..