09A, 5 SPD. A/T

Multi-function Transmission Range (TR) switch -F125-, removing, installing and adjusting, 09A, 5 Spd. A/T

Special tools and equipment

T10091 Adjusting device:

VAG 1331 Torque wrench or equivalent:

Removing multi-function TR switch
- Check whether a coded radio is installed. If so, obtain anti-theft coding.
- Switch ignition off and disconnect battery Ground strap.
- Remove battery.
- Remove battery carrier.
- Shift selector lever into "P" position.





- Remove nut (arrow).
- Pull lever -1- off selector shaft.
- Pull off multi-function TR switch connector -2-.
- Remove Multi-function TR switch -F125- -3-.

Installing and adjusting multi-function TR switch





- Install Multi-function TR switch -F125- on selector shaft.

Installation position:
Groove -1- in selector shaft must align with Multi-function TR switch -F125- marking -2-.





- Screw in Multi-function TR switch -F125- securing bolts (arrows) hand tight.
- Place adjusting device on selector shaft and secure.
- Shift lever/selector shaft on transmission to position "N".
- Turn switch until hole on switch housing -1- aligns with hole of adjusting device.





- Insert pin -2- from adjusting device.
- Tighten Multi-function TR switch -F125- securing bolts (arrows) to 6 Nm.
Further installation in reverse order
- Check selector lever cable adjustment.
- Enter radio code.
Tightening torques