Ignition System: Service and Repair

Ignition Components (vehicles With Engine Code AWP, AWW), Removing And Installing







1. Connector
- Black, 4-pin
2. Ignition coil with power output stage (Ignition Coil 1 with Power Output Stage -N70-, Ignition Coil 2 with Power Output Stage -N127-, Ignition Coil 3 with Power Output Stage -N291-, Ignition Coil 4 with Power Output Stage -N292-)
3. Snap ring
- For ignition coil with power output stage (Ignition Coil 1 with Power Output Stage -N70-, Ignition Coil 2 with Power Output Stage -N127-, Ignition Coil 3 with Power Output Stage -N291-, Ignition Coil 4 with Power Output Stage -N292-)
4. Spark plug, 30 Nm
- Remove and install with 3122 B
- Type and spark plug gap, test data, spark plugs
5. Connector
- Black, 3-pin
- Terminals of sensor and connector are gold-plated
6. 10 Nm
7. Camshaft Position (CMP) Sensor -G40-*
8. 25 Nm
9. Washer
- Conical
10. Face plate
- For Camshaft Position (CMP) Sensor 2 -G163-
- Note position when installing
11. 20 Nm
- Tightening torque affects function of Knock Sensor (KS)
12. Knock Sensor (KS) 1 -G61-*
- Terminals of sensor and connector are gold-plated
- Component location: Cylinder block, intake side
13. Knock Sensor (KS) 2 -G66-*
- Terminals of sensor and connector are gold-plated
- Component location: Cylinder block, intake side
14. Connector
- 2-pin
- Terminals are gold-plated
- Black for Knock Sensor (KS) 1 -G61-
- Black for Knock Sensor (KS) 2 -G66-
- Mark connector before removing
15. Ground (GND) wire
- Do not loosen or tighten unless ignition is switched off.
16. 10 Nm
- Do not loosen or tighten unless ignition is switched off.