Selector Mechanism, Disassembling and Assembling

Selector mechanism, disassembling and assembling, 09A, 5 Spd. A/T





Note: Lubricate mounting points and contact surfaces with grease, Part No. G 052 142 A2.

1 - Selector lever handle
2 - Sleeve
^ Locates in selector lever handle
^ Prevents selector lever handle from being pulled off

3 - Cover
^ With symbol panel
^ Clipped into frame -item 5-

4 - Printed circuit
^ Can be checked in electrical test and in measured value block

5 - Frame
^ With cover panel

6 - Cable clip
^ Clipped into frame -item 5-

7 - Bracket
^ For selector lever cable
^ Fitted on front tunnel heat shield

8 - Locking plate
^ Secures selector lever cable to mounting bracket
^ Always replace

9 - Selector lever cable
^ Do not bend or kink
^ If outer cable is damaged the selector lever cable must be replaced
^ Do not grease cable eye and ball socket

10 - Collared nut, 10 Nm
^ For cover to mounting bracket
^ Qty. 4
^ Self-locking
^ Always replace

11 - Cover
^ For mounting bracket
^ With bonded seal

12 - Hex bolt
13 - Locking pawl
^ For selector lever lock
^ Grips into cable lever of mounting bracket

14 - Shift lock solenoid -N110-
^ Can be replaced with selector mechanism installed
^ Can be checked in electrical test and in measured value block

15 - Mounting bracket
16 - Locking cable
^ For ignition key removal lock
^ Must not be kinked
^ Checking operation of the ignition key withdrawal lock.

17 - Steering lock
18 - Clip
^ Position: push on clip from above. The angled ends of clip face steering lock.