02M, 5 and 6 SPD. M/T

Selector cables, assembly overview, 02M, 5 and 6 Spd. M/T





Note: Lubricate all mountings and sliding surfaces with Polyurea grease Part No. G 000 450 02.

1 - Gear selector cable
^ Press onto gear shift guide

2 - Gate selector cable
^ On relay lever

3 - Circlip
4 - Circlip
^ Do not damage cables when removing

5 - Shift housing
6 - Hex bolt, 25 Nm
^ For support bracket

7 - Support bracket
8 - Bushing
^ Support bracket mounting to transmission

9 - Distance piece
10 - Cable locking mechanism
^ For gate selector cable to relay lever
^ Replace after removing from relay lever item 11
^ From 01.01 with holes
^ Not necessary to be replaced
^ Secured with securing clip

11 - Relay lever
12 - Bushing
13 - Circlip
14 - Shoe
15 - Transmission selector lever
^ With balance weight
^ Install so that master spline aligns with selector shaft
^ After installing adjust gear selector mechanism
^ Always replace

16 - Hex nut, 20 Nm
^ Self-locking
^ Always replace

17 - Cable locking mechanism
^ For gear selector cable to gear selector lever
^ Replace after removing from transmission selector lever item 15
^ From 01.01 with holes
^ Not necessary to be replaced
^ Secured with securing clip





Installed position of transmission selector lever/relay lever
1 - Gear selector lever
With balance weight
2 - Relay lever
Locates in guide rail of gear selector lever via shoe (arrow)