Instrument Cluster / Carrier

Instrument Cluster Multi-Pin Connector Assignments From 06.99

NOTE:
- Instrument cluster must not be disassembled.
- Troubleshooting specific systems and circuits
- Additional information







Multi-pin connectors on instrument cluster

32-pin connector -1-, blue
- Basic functions
- Connector assignments

32-pin connector -2-, green
- Expanded functions
- Connector assignments







32-pin multi-connector, blue
1. Terminal 15 - positive (ignition on)
2. Indicator lamp for turn signal, right
3. Output signal 1 from electronic speedometer
4. Open
5. Fuel gauge
6. Airbag Malfunction Indicator Lamp (MIL)
7. Terminal 31 - sensor/sender Ground (GND)
8. Engine Coolant Temperature (ECT) gauge
9. Terminal 31 - Ground (GND)
10. Oil pressure warning lamp
11. Open
12. Terminal 61 - warning lamp for Generator (GEN),
13. 16 - Open
16. Warning lamp for rear hatch/trunk lid open
17. Terminal 56a - indicator lamp for high beam headlight
18. Indicator lamp for turn signal, left
19. Open
20. Terminal 58b - instrument cluster illumination
21. Driver's door open warning buzzer
22. Warning lamp for low Engine Coolant Level (ECL)
23. Terminal 30 - positive (B+)
24. Terminal 31 - Ground (GND)
25. Data Link Connector (DLC) K-wire
26. Parking lights, right (signal for "lights on" warning buzzer)
27. Parking lights, left, (signal for "lights on" warning buzzer)
28. Input signal - Speedometer Vehicle Speed Sensor (VSS)
29. Brake fluid level warning lamp
30. Terminal 86s - Ignition key warning buzzer
31. Seat belt warning lamp/buzzer
32. Open







32-pin connector, green
1. Open
2. Reading coil for immobilizer
3. Open
4. Open
5. W-wire
6. Rear spoiler
7. Brake pad wear indicator
8. Open
9. Open
10. Low fuel level warning
11. Signal for vehicle stationary
12. Open
13. Warning lamp for dual circuit brake system and handbrake
14. Open
15. Open
16. Open
17. Reading coil for immobilizer
18. Open
19. Interface - CAN Data Hi-Bus
20. Interface - CAN Data Lo-Bus
21. Open
22. Open
23. Open
24. Open
25. Open
26. Open
27. Interface - On Board Diagnostic (OBD) CAN Data Hi-Bus
28. Interface - On Board Diagnostic (OBD) CAN Data Lo-Bus
29. Open
30. Output signal 2 from electronic speedometer (where applicable)
31. Selector lever display (automatic transmission)
32. Open