Multi-Function Transmission Range (TR) Switch, Replacing

Multi-Function Transmission Range (TR) Switch, Replacing

Recommended special tools and equipment







- V.A.G 1331 torque wrench (5 to 50 Nm)







- T10173 Setting gauge (vehicles with 09G transmission)

Requirements

Vehicles with 01M transmission
- Selector lever must be in -P- position.

Vehicles with 09G transmission
- Selector lever must be in -N- position.

Continue for all vehicles
- Parking brake must be engaged or else day time driving lights will be switched on.
- Ignition switched off.

Work procedure:
- Vehicles with 01 M transmission.
- Vehicles with 09G transmission.

Work sequence (vehicles with 01 M transmission)

NOTE: Multi-function switch is located at rear on transmission.







- Disconnect connector from Multi-Function Transmission Range (TR) Switch -F125-
- Remove mounting bolt and retainer.
- Remove Multi-Function Transmission Range (TR) Switch.
- Replace O-ring.

Installation is in reverse order of removal.
- Tighten bolt to 10 Nm.
- Erase DTC memory of Transmission Control Module (TCM). Diagnostic mode 4: Reset/erase diagnostic data. Diagnostic Mode 4: Reset/Erase Diagnostic Data
- Generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes

Work sequence (vehicles with 09G transmission)
- Remove air filter housing.







- Pry off selector lever cable -1- from lever -4- using an open-end wrench 10 mm -3-
- Compress locking mechanism (arrows) and pull selector lever cable out of mounting bracket.
- Disconnect connector -2- from Multi-Function Transmission Range (TR) Switch -F125-







- Remove mounting nut -1-
- Remove compression spring -2- and lever -3- from shift rod -4-.







- Remove mounting nut -1-
- Carefully bend hooks of locking washer -2- back using a screwdriver.

NOTE: If a hook breaks off, replace locking washer.

- Remove mounting bolts -5-.
- Remove Multi-Function Transmission Range (TR) Switch -F125- -4- with washer -3- and locking washer from shift rod -6-.

Installing and adjusting







- Connect Multi-Function Transmission Range (TR) Switch -F125- (-4-) to shift rod -6-.
- Screw in mounting bolts -5- for multi-function switch hand-tight.







- Place setting gauge (T10173) on shift rod -2-.
- Rotate Multi-Function Transmission Range (TR) Switch -1- until tab on connector engages in groove of adjustment tool.
- Fasten setting gauge T10173 onto shift rod -2- using bolt -3-.
- Tighten mounting bolts (arrows) of Multi-Function Transmission Range (TR) Switch.

Tightening torque: 6 Nm

- Remove adjustment tool (T10173) from shift rod.

Rest of installation is in reverse order of removal.
- Check adjustment of selector lever cable.
- Erase DTC memory of Transmission Control Module (TCM). Diagnostic mode 4: Reset/erase diagnostic data. Diagnostic Mode 4: Reset/Erase Diagnostic Data
- Generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes