Ignition Switch: Service and Repair

Ignition/Starter Switch, Removing and Installing

CAUTION:
Before beginning repairs on the electrical system:
- Obtain the anti-theft radio security code.
- Switch off all electrical consumers.
- Switch off ignition and remove ignition key.
- Disconnect negative ( - ) battery terminal.
- When disconnecting and reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified.

Special tools and equipment
Sealant "D2"

Removing
- Disconnect battery.
- Remove upper and lower steering column switch trim.
- Disconnect multi-pin connector from ignition/starter switch.







- Remove locking fluid (paint) from threaded holes of screws -A-.
- Loosen two screws -A- slightly and pull ignition/starter switch out from steering lock housing in direction shown -arrow-.

Installing
- Push ignition/starter switch into steering lock housing.

NOTE: When installing the ignition/starter lock switch ensure that the ignition/starter lock switch and the lock cylinder are in the same position, e.g. "ignition on".

- Tighten screws and seal securing holes with sealant D2.
- Connect multi-pin connector to ignition/starter switch.
- Install steering column switches and steering wheel trim.