Ignition Components, Removing and Installing

Ignition Components, Removing And Installing (Vehicles With Engine Code AWP, AWV, BKF, BNU)







NOTE: Motronic Engine Control Module (ECM) -J220- with harness connectors

1. Connector
- Black, 4-pin
2. Ignition coil with power output stage (-N70-, -N127-, -N291-, -N292-)
3. Snap ring
- Replace if damaged
4. Spark plug, 30 Nm
- Type and spark plug gap. test data, spark plugs
5. Connector
- Black, 3-pin
- Terminals of sensor and connector are gold-plated
6. 10 Nm
7. Camshaft Position (CMP) sensor -G40-*
8. 25 Nm
9. Washer
- Conical
10. Face plate
- For Camshaft Position (CMP) sensor -G40-
- Note position when installing
11. 20 Nm
- Tightening torque affects function of Knock Sensor (KS)
12. Knock Sensor (KS) 1 -G61-
- Terminals of sensor and connector are gold-plated
- Component location: Cylinder block, intake side
13. Knock Sensor (KS) 2 -G66-
- Terminals of sensor and connector are gold-plated
- Component location: Cylinder block, intake side
14. Connector
- 2-pin
- Terminals of sensor and connector are gold-plated
- Mark connector before removing
15. Ground (GND) wire
- Do not loosen or tighten unless ignition is switched off.
16. 10 Nm
- Do not loosen or tighten unless ignition is switched off.