Additional Information, Engine Control Module, Replacing

Engine Control Module, Replacing

Removing
- Print out control module identification and previous control module coding.

NOTE: If display does not correspond to the control module version installed in the vehicle, replace control module. For latest part number for engine control module electronic parts catalog "ETKA".

- Switch off ignition.
- Remove plenum chamber inner cover on left side.







- Carefully press off retaining tab - arrow -.
- Release connector from control module and disconnect.
- Remove control module.

Installing
- Connect connector to control module and lock.
- Place new control module into retaining frame.
- Continuously code control module in "Guided fault finding".
- Read Diagnostic Trouble Code (DTC) memory of new engine control module and erase DTC memory if necessary.
- Road test vehicle.

Observe applicable safety precautions during road test
- Read Diagnostic Trouble Code (DTC) memory of engine control module, correct DTCs if necessary and erase DTC memory.
- Install inner cover on left side of plenum chamber.