Output Speed Sensor

Sender For Transmission Output RPM, Checking

Requirements

- Respective fuses must be OK.
- Battery voltage must be at least 11.5 volts.
- Selector lever must be in -P- position.
- Ground (GND) connections to transmission must be OK.
- Transmission must be OK mechanically.

Test sequence
- Disconnect 20-pin harness connector to Direct Shift Gearbox (DSG) Mechatronic -J743- on transmission.

Observe safety precautions.
- Check harness connector for contact corrosion and ingress of water.

If harness connector is not OK:
- Repair malfunction.
- Erase DTC memory of Transmission Control Module (TCM). Diagnostic mode 4: Reset/erase diagnostic data. Diagnostic Mode 4: Reset/Erase Diagnostic Data
- Generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes

If harness connector is OK:
- Replace Direct Shift Gearbox (DSG) Mechatronic -J743-.

NOTE: Sender for transmission output RPM -G195- and Sender 2 for transmission output RPM -G196- are components of the Mechatronic unit and cannot be replaced individually.