Clutch Installation, Preparatory Work

Clutch Installation, Preparatory Work, 02E, 6 SPD. DSG A/T

Clutch as replacement part





1 - Clutch
2 - Ten securing rings
Rings have varying thickness. They are stepped in 0.1-mm increments.
For this, please observe instructions in Clutch, installing and adjusting. Clutch, Installing and Adjusting

3 - Cap (sealing cap) for clutch
Make sure that inner sealing lip is not damaged .

4 - Securing ring
For cap (sealing cap)

5 - Securing ring
For clutch cap





- Already when removing clutch from packaging, press on clutch cap.

Clutch cap and clutch carrier lying beneath should be prevented from slipping out of inner clutch.





- Check four piston rings - A - for proper seating.

Note:
Ends of the rings must not stand over one another .





Important! Position of clutch cap on clutch.

- Before removing clutch cap, check whether a marking - arrow A - is applied on clutch.
- If there is no marking present, make a color marking yourself. Later, the tab of the clutch cap - arrow B - must be installed again on this marked location - arrow A -.
- In case of a new clutch being installed, remove securing ring - 1 -.





- Carefully remove clutch cap from clutch - arrows - and set it aside.

CAUTION!
Prevent the removal or lifting of the clutch carrier Not even slightly! The clutch discs can rotate themselves.

Set down clutch so that it cannot fall over.

This prepares the clutch for installation.