Components In Passenger Compartment, Servicing

Components In Passenger Compartment, Servicing







CAUTION:
Before beginning repairs on the electrical system:
- Obtain the anti-theft radio security code.
- Switch off all electrical consumers.
- Switch off ignition and remove ignition key.
- Disconnect negative ( - ) battery terminal.
- When disconnecting and reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified.
- Immediately plug open connections on A/C components to prevent dirt and moisture contamination.

NOTE:
- Before carrying out any work on the A/C refrigerant system, refer to A/C refrigerant system safety measures.
- System components identified with an * must only be serviced or replaced after discharging refrigerant system. Use Kent Moore ACR4 or equivalent.

1. Heating and A/C controls
- With A/C switch -E35-
- With fresh air blower switch -E9-
- With switch for fresh air blower and recirculated air -E184-
2. Dust and pollen filter
3. Side window air outlet
4. Side air outlets
5. Center air outlet console
6. Instrument panel cross member
- Loosening and tightening
7. Servo motor for fresh/recirculating air door -V154-
8. Fresh air blower -V2-
- Removing See Fig. 1
9. Fresh air blower series resistance with fuse -N24-
- Removing
10. Intermediate duct
11. Cables
12. Rear footwell duct
13. Gasket
14. Connecting duct
- With front footwell air outlet
15. Heater/evaporator unit*
16. Heater core*
- Removing heater/evaporator unit, disassembly and assembly
- Always use new coolant after replacement
17. Heater core/bulkhead seal
- Note installation position
18. Defroster duct
- Replacing:
- Remove instrument panel
- Loosen instrument panel cross member.
19. Instrument panel
20. Center air outlet duct
21. Defroster air outlet panel