Body Control Systems: Locations

Central Locking And Convenience Systems, Assembly Overview







1. Coupling station
- Component location: Lower A-pillar, covered by footwell trim.
- Remove lower A pillar trim
2. Door control module, RF
- integrated in window regulator motor.
3. Door lock, RF
- Door lock is secured to assembly carrier.
- Electrical central locking system is integrated in door lock.
4. Coupling station
- Component location: B-pillar
- Removing lower B-pillar trim
5. Door control module, RR
- Integrated in window regulator motor.
6. Door lock, RR
- Door lock is secured to assembly carrier.
- Electrical central locking system is integrated in door lock.
7. Motor for fuel tank lid unlock V155
- Component location: Under right luggage compartment trim.
8. Trunk lid/Tailgate lock
- Component location: screwed onto lid.
9. Trunk lid positioning motor
- Component location: At trunk lid, inside.
10. Door lock, LR
- Door lock is secured to assembly carrier.
- Electrical central locking system is integrated in door lock.
- Removing and installing:
11. Coupling station
- Component location: in area of rear roof crossmember, covered by roof trim.
- Lower molded headlining at rear
12. Anti-ft alarm horn
- Component location: in area of C-pillar, covered by luggage compartment trim.
Remove luggage compartment trim
13. Door control module, LR
- Integrated in window regulator motor.
14. Door lock, LF
- Door lock is secured to assembly carrier.
- Electrical central locking system is integrated in door lock.
15. Coupling station
- Component location: B-pillar.
- Removing lower B-pillar trim.
16. Central switch for window regulator
- Component location: installed in door trim.
- Removing and installing central switch for window regulator
17. Door control module, LF
- Integrated in window regulator motor.
18. Coupling station
- Component location: Lower A-pillar, covered by footwell trim.
- Remove lower left A-pillar trim
19. Central control module for comfort system
- Component location: Installed on vehicle floor, in front of drivers seat in an E-box.
- To install and remove, left sill panel trim must be removed and floor carpet must be lifted
20. Antenna for remote control
- Component location: under right, A-pillar trim.
- Removing A-pillar trim
21. Front hood switch
- Contact switch for anti-ft warning system, cannot be replaced individually.
- Component location: On hood lock.
- Remove hood lock