Sunroof / Moonroof: Locations

Sunroof With Glass Panel, Assembly Overview







1. Glass panel for sunroof (one-piece safety glass)
- Removing glass panel for sunroof
- Installing glass panel for sunroof
- Adjusting glass panel for sunroof
2. Panel seal
- Adjusting panel seal
- Seal joint at center in rear area.
- Replacing panel seal
3. Sun protection
- Removing and installing sun protection
4. Countersunk screws
- Qty 4
- 1.8 Nm
- Screws are microencapsulated and must always be replaced after removing.
5. Slider
6. Upper trim
- Up to CW 35/02
7. Lower trim
- Up to CW 35/02
8. Water channel
- Removed together with slotted guide rail
9. Guide locking hook
10. End piece
- Use butyl adhesive sealing cord AKL 450 005 05 for sealing.
11. Installation unit
- Removing and installing installation unit:
- If necessary use special grease G 000 450 02 exclusively to grease guide channels, otherwise functions cannot be guaranteed.
12. Bolt
- Qty 3
- 3.5 Nm
- Screws are microencapsulated and must always be replaced after removing.
13. Hex wrench for emergency operation
- Clipped in on E-drive motor cover.
14. Electrical drive motor
- Adjusting drive motor (0 position):
15. Spring
16. Wind deflector
17. Torx screw
- Torx key T25
- 4.5 Nm
18. Rear guide
- Removed together with slotted guide rail
19. Slotted guide rail
20. Gap bracket
- Removed together with slotted guide rail
21. Boots
- As of CW 36/02

NOTE: Boots and trim must not be replaced against each or. otherwise, clearance for mechanical components is not guaranteed.