Cylinder Head Assembly: Specifications

Cylinder Head





Insert NEW cylinder head bolts and tighten by hand

Tighten cylinder head bolts in tightening sequence as follows:
Tighten all bolts 60 Nm
Tighten all bolts 1/4 turn (90°) further using a rigid wrench.
Afterward, tighten all bolts another 1/4 turn (90°) further.

Cylinder head distortion
Max. permissible distortion 0.05 mm

Camshaft Bearing Cap





Install bearing caps - 2 - and - 4 - for both camshafts according to markings.
Fasten caps alternating diagonally and then tighten them to 10 Nm (pay attention to alignment pins).

Install both bearing caps - 1 - on chain sprockets of intake and exhaust camshafts.





Both markings on camshafts must be aligned with both arrows on bearing caps - arrows -.





Install bearing caps - 0 -, - 3 - and - 5 - and tighten to 10 Nm (pay attention to alignment pins).