Oil Pump, Crankcase Breather and Oil Spray Jets,

Oil pump, crankcase breather and oil spray Jets, removing and installing
Removing and installing oil pan, oil filter and oil cooler
Removing and installing chain driven type oil pumps





1. Oil pump
- Only replace complete
2. Spray jet valve, 40 Nm
3. O-ring
- Always replace
4. 45 Nm
5. Idler roller
6. 10 Nm
7. 10 Nm
8. Breather housing
9. Gasket/breather - plate
- Always replace
10. Oil check valve, 25 Nm
- Location see Fig. 1
11. Connector
12. 15 Nm
13. Oil distribution pipe
- For oil spray jets for piston cooling
- Location Fig. 1
14. Cylinder block
15. 10 Nm
- Insert with locking fluid "D6"
16. Oil spray jet
- For piston cooling
17. Gasket
- Metal
- Always replace
18. Oil - temperature sender (G8), 10 Nm
- For oil temperature gauge
- White
- If sealing ring is leaking nip open and replace.
19. Oil
- Replacing
- If a PTFE (teflon) seal was used, it must be replaced only with another PTFE seal
- Install PTFE seals without oil or grease
20. Tensioning element
- Secure before removing, removing toothed belt
21. 10 Nm
- Insert with locking fluid "D6"
22. O-ring
23. Washer
24. Bearing bushing
25. 25 Nm
26. Tensioning lever