Ignition System: Locations

Ignition Components, Removing And Installing (Vehicles With Engine Code ATW, AUG, AWM)







NOTE: Engine Control Module (ECM) with harness connectors.

A parts: Vehicles with engine code ATW
B parts: Vehicles with engine code AUG, AWM

1. Connector
- Black, 4-pin
2. Ignition coil with power output stage (Ignition Coil 1 with Power Output Stage -N70-, Ignition Coil 2 with Power Output Stage -N127-, Ignition Coil 3 with Power Output Stage -N291-, Ignition Coil 4 with Power Output Stage -N292-)
- Checking
- Tighten mounting bolts to 10 Nm
3. Seal
- Replace if damaged
4. Spark plug, 30 Nm
- Type and spark plug gap. test data, spark plugs
5. 3-pin harness connector
- Terminals are gold-plated
- Brown for Knock Sensor (KS) 1 -G61-
- Black for Knock Sensor (KS) 2 -G66
6. 20 Nm
- Tightening torque affects function of Knock Sensor (KS)
7. Knock Sensor (KS) 1 -661-"
- Terminals of sensor and connector are gold-plated
- Checking
8. Knock Sensor (KS) 2 -666-"
- Terminals of sensor and connector are gold-plated
- Checking
9. Connector
- Black, 3-pin
10. 10 Nm
11. Camshaft Position (CMP) Sensor 2 -6163-*
12. 25 Nm
13. Washer
- Conical
14. Face plate
- For Camshaft Position (CMP) Sensor 2 -G163-
- Note position when installing
15. Ground (GND) wire
- Do not loosen or tighten unless ignition is switched off.
16. 10 Nm
- Do not loosen or tighten unless ignition is switched off.