Parts of Ignition, Removing and Installing

Parts Of Ignition, Removing And Installing







NOTE:
- Cylinder bank 1 is located in direction of travel, right.
- Cylinder bank 2 is located in direction of travel, left.
- Engine Control Module (ECM) with harness connectors.

1. Spark plug, 30 Nm
- Type and spark plug gap. test data, spark plugs
2. Spark plug connectors with ignition wires
- Check ignition coil
3. Spacer sleeve
4. Rubber grommet
5. 10 Nm
6. Ignition Coil -N152-
- with power output stage
- with marking for ignition wires, do not interchange
7. Connector
- black, 5-pin
8. 3-pin harness connector
- Terminals are gold-plated
9. 20 Nm
- Tightening torque affects function of Knock Sensor (KS)
10. Knock Sensor (KS) 2 -G66-*
- Cylinder bank 2
- Terminals of sensor and connector are gold-plated
11. Knock Sensor (KS) 1 -G61-*
- Cylinder bank 1
- Terminals of sensor and connector are gold-plated
12. 10 Nm
13. Camshaft Position (CMP) Sensor 2 -G163-*
- Cylinder bank 2
14. 25 Nm
15. Washer
- Conical
16. Face plate
- for Camshaft Position (CMP) sensor
- note position when installing
17. Connector
- black, 3-pin
- for Camshaft Position (CMP) Sensor -G40- or Camshaft Position (CMP) Sensor 2 -G163
18. Camshaft Position (CMP) Sensor -G40-*
- Cylinder bank 1