Towing Recognition Control Module J345, Servicing

Towing Recognition Control Module J345, Servicing


Towing Recognition Control Module J345, removing and installing

NOTE: Removal and installation of Hella and Westfalia control modules is the same as described below:

Removing:

CAUTION:
- Switch off all electrical consumers.
- Switch off ignition and remove ignition key.
- Remove right side panel trim in luggage compartment.







NOTE: The number of connections - arrows - and connector layout at J345 may differ from that illustrated here.

- Disengage electrical connections - arrows -.
- Remove screw -1 - and remove control module upward out of bracket.

Installing:
Install in reverse order of removal, noting the following:

NOTE: After installing a new Westfalia control module, it must be coded.