Delta Radio

Delta Radio

• Replacement part number for radio unit is located on a sticker on the radio unit housing.

• Ask the customer for the radio unit code number before removing. If radio unit is replaced, always activate anti-theft coding, --> Owner's Manual. The customer must be informed of the new code number.

Special tools, testers and auxiliary items required

• Radio removal tool (T10057)

Removing

Before starting repair work, perform the following:

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- If necessary, remove CDs remaining in the unit. Refer to --> Owner's Manual.

Now, perform the following work procedure:

- Slide Radio Removal Tool (T10057) into slots designed for it on radio unit at left and right until it engages audibly - arrows -.





Top L - upper and lower left.

Top R - upper and lower right.

- Remove radio unit from installation opening using radio removal tool - arrows - until the connections on the rear side of the unit are reached.





- Press together the connector lock in direction of - arrows -.





- Then swing mounting bracket up in direction of - arrow - and disconnect harness connector.





- Release connector - arrow - from antenna connector.





- Press spring - arrow - and remove radio removal tool forward.





Installing

- Reconnect connectors on radio unit.

- Slide radio unit straight into installation opening until it engages in installation bracket.

• While sliding in the radio unit, do not press on the display or control buttons under any circumstances because the radio unit may be damaged by doing this.

- Check coding of radio unit and code radio unit again if necessary.

Radio unit coding, adapting components, radio. Refer to --> [ Radio Components, Adapting ] Programming and Relearning.