Air Cleaner Housing: Locations

Air Filter, Assembly Overview

Connection to compressor for air suspension, separating







1. Intake tube
2. Spring-type clip
3. Intake tube
4. 6 Nm
5. Mass air flow (MAF) sensor G70 with intake air temperature (IAT) sensor G42
6. Oil seal
- Replace if damaged
7. Air filter upper part
- On the right side with connection to Secondary Air Injection (AIR) Pump Motor V101
8. Filter element
9. To Secondary air injection (AIR) pump motor V101
10. Air duct
- Secured to lock carrier
11. Rubber bushing
- Clipped into longitudinal member
12. Air filter lower part
- To remove the right lower part of air filter, the bracket for the right engine cover must be removed.
13. 10 Nm
14. Connection from compressor for air suspension
- Removal







Removing bracket for right engine cover
- Press in the retaining tab - 1 - from below and pull out the bracket in direction of - arrow -

Connection to compressor for air suspension, separating







- Separate the connecting line at the right air filter - arrow - as follows:
- Carefully pry off the green circlip - 1 - using a screwdriver. Then press the clamping ring - 2 - in direction of - arrow -







- Pull only the slackened line - B - from the connection - A - at the air filter.