Fluid Filter - ASMT: Service and Repair

Change oil and filter 02E, 6 Speed Direct Shift A/T
- Follow sequence of each of the following instructions until oil change is completed.
- Connect VAS tester and identify vehicle in Guided Fault Finding.
- Direct shift Transmission
- Check oil level





- Engine off - do not start!

Only start engine when requested to do so. Not right now.

- Place drip tray VAG 1306 underneath transmission.
- Connect VW Tester and press Check oil level in Guided Function.





- Slowly remove filter housing.
- Before removing filter housing from transmission, tip it slightly in its seating.

This allows oil to flow back into transmission from filter housing.





- After you have inserted filter with - shoulder - downward, tighten housing to 20 Nm.
- Raise vehicle.
- Remove noise insulation tray.
- Place used oil collection and extraction device V.A.G 1782 or drip tray V.A.G 1306 under transmission.





- Remove inspection plug near pendulum support - arrow -.

A black plastic overflow tube is located in this hole (with 8 mm hex socket head, torque specification: 3 Nm). Its length determines oil level in transmission.

- Remove this oil tube.

About 5 liters of oil will drain.
- Reinstall overflow tube, 3 Nm.





- Install adapter - A - from Adapter For Oil Filling VAS 6262 hand-tight in inspection hole.





Shake oil containers before opening.

- Fill 5.5 liter DSG oil.

To change bottles, shut-off valve can be closed or Adapter For Oil Filling VAS 6262 can be held higher than transmission.

- Move through VAS 5051 until DSG oil temperature is displayed.





- Now start engine.
- Press brake and shift into each selector lever position for approx. 3 seconds. Place lever in position P again.

Do not switch off engine!

With an oil temperature of 35° to 45° Celsius:
- Disconnect quick-release coupling of Adapter For Oil Filling VAS 6262 with engine running.
- Let excess oil drain.





- As soon as oil has run out (it begins to drip), remove Adapter For Oil Filling VAS 6262 and install plug with new seal.

Tightening torque: 45 Nm

- Turn off engine.

Drained oil must not be used to fill again.

Dispose of oil in an appropriate manner.

This completes changing oil and filter.

Oil level in transmission is correctly adjusted.

- Install noise insulation tray.