Transmission, Installing

Transmission, Installing

Installation is performed in the reverse order of removal. However, important steps are listed here:

- Inspect the needle bearing - arrow - in the crankshaft. If it is damaged or has blue tarnish, it must be replaced, refer to one of the following:

Gas engines.

Diesel engines.

- If it is not damaged, lubricate it lightly with high temperature grease (G052133A2).





- Transmission pins (not splines) must also be lightly lubricated.

- Make sure the locating sleeves are seated correctly between the engine and transmission.

- Check the correct seating of the intermediate plate.

The engine and transmission must be brought together by hand until both flanges touch completely!

If this is not the case, it will not run correctly!

- Adjust the transmission mount until the engine and transmission are aligned.

- Guide the selector lever cable into the cable mounting bracket as soon as possible.

Check the cable when raising the transmission. Do not fail to place it in the cable mounting bracket early.

Do not grease the cable.

- Selector lever cable lock washers must be reconditioned.





- Always adjust the selector lever cable. Refer to => [ Selector Lever Cable Adjustment, through 02.2009 ] Adjustments.

- Check the coolant level and fill if necessary, refer to one of the following:

Gas engines.

Diesel engines.

Tightening specifications, refer to => [ Transmission to Engine Tightening Specifications ] Transmission to Engine Tightening Specifications.