Instrument Cluster / Carrier

Instrument Cluster Multi-pin Connector Assignments From m.y. 2000

NOTE: Pin assignments dependent on available/optional equipment present and applicable engine versions.

32 pin multi-connector -T32-, blue







1. Terminal 15 - positive (ignition on)
2. Indicator lamp for turn signal, right
3. Output signal 1 from electronic speedometer
4. Open
5. Fuel gauge
6. Airbag Malfunction Indicator Lamp (MIL)
7. Terminal 31 - sensor/sender Ground (GND)
8. Engine Coolant Temperature (ECT) gauge
9. Terminal 31 - Ground (GND)
10. Oil pressure warning lamp
11. Open
12. Terminal 61 - warning lamp for Generator (GEN),
13 - 15. Open
16. Warning lamp for rear hatch/trunk lid open
17. Terminal 56a - indicator lamp for high beam headlight
18. Indicator lamp for turn signal, left
19. Warning lamp for Anti-lock Brake System (ABS)
20. Terminal 58b - instrument cluster illumination
21. Driver's door open warning buzzer
22. Warning lamp for low Engine Coolant Level (ECL)
23. Terminal 30 - positive (B+)
24. Terminal 31 - Ground (GND)
25. Data Link Connector (DLC) K-wire
26. Parking lights, right (signal for "lights on" warning buzzer)
27. Parking lights, left, (signal for "lights on" warning buzzer)
28. Input signal - Speedometer Vehicle Speed Sensor (VSS)
29. Brake fluid level warning lamp
30. Terminal 86s - Ignition key warning buzzer
31. Seat belt warning lamp/buzzer
32. Open

32 pin multi-connector -T32a-, green







1. Open
2. Reader coil for immobilizer 1
3. Indicator lamp for parking light*
4. CAN Data Bus, shielded input
5. W-wire*
6. Indicator lamp for low windshield washer fluid
7. Brake pad wear indicator
8 - 9. Open
10. Low fuel level warning
11. Signal for vehicle stationary*
12. A/C clutch cut-off - Engine Coolant Temperature (ECT) signal
13. Warning lamp for dual circuit brake system and handbrake
14. ASR/ESP Indicator lamp (traction control)*
15 - 16. Open
17. Reading coil for immobilizer 2
*. Where applicable
18. Oil level thermal sensor*
19. Interface - CAN Data Hi-Bus
20. Interface - CAN Data Lo-Bus
21. Open
22. Hood alarm switch*
23. Multi Function Trip Computer (MFI) - top row (forwards)
24. MFI - bottom row (backwards)
25. MFI - memory switch: reset
26. MFI - ambient temperature display
27. On Board Diagnostic (OBD) Interface - CAN Data Hi-Bus
27. On Board Diagnostic (OBD) Interface - CAN Data Lo-Bus
29 - 32. Open
*. Where applicable