Selector Lever Cable, Checking and Adjusting

Selector lever cable, checking and adjusting, 09A, 5 Spd. A/T

Checking
- Shift selector lever into "P" position.





- Pull selector lever cable -1- upward off lever/selector shaft -4- and position so that end is free to move.

Note: Do not bend or kink the selector lever cable.

- Shift selector lever from "P" to "2".
- Check front protective sleeve on selector lever cable for damage, if necessary replace cable.
- Shift selector lever into "P" position.
^ Selector lever mechanism and selector lever cable must move freely, if necessary replace selector lever cable) or service selector lever mechanism.

- Press selector lever cable onto lever/selector shaft using a pair of pliers.
- Replace circlip -3- if it has been removed.

Adjusting
- Shift selector lever into P position.





- Loosen bolt -2- at front ball socket of selector lever cable -1-
- Bring selector shaft lever in position P on transmission.
Locking lever must engage in park lock wheel, both front wheels are blocked (cannot be turned together in a direction).
- Tighten bolt -2- (13 Nm).
- Check gear change mechanism.