Selector Lever Handle, Removing and Installing

Selector lever handle, removing and installing, 09A, 5 Spd. A/T
There are various handles which are removed and installed in different ways.

Before starting disassembly work:





- Slide sleeve on selector lever downward and check color of plastic part in handle (arrow).

Red-brown plastic: This handle can replace handle with black plastic part.

Removing
- Pull upward on handle but do not press button.

Note: If button is inadvertently pressed, use compressed air and carefully blow button outward again.





- Ensure always that button is projecting at lease 10 mm -a- when installing.
- Slowly pull button by hand past perceptible pressure point so that it will not fall back again.
- Push handle onto selector lever to install

Removing handle with black plastic part
- Shift selector lever to position "R".





- Slide sleeve -1- downward.
- Pull button -2- out of handle -3- just enough that pull lever (arrow) hangs downward.
- Pull handle off selector lever.

Installing
- Shift selector lever to position "R".





- Pull button -2- out of handle -3- just enough so that pull lever (arrow) hangs downward.
- Press handle on selector lever onto stop.

Installation position: Button points to driver.

- Pull button out slightly and guide pull lever (arrow) into handle.
- Press button so that pull lever engages in pull rod -4-.

Button must now spring back onto stop.

- Slide sleeve -1- upward in twisting motion until two wide tabs of sleeve locate in slots of handle and sleeve can be felt to engage in handle.
- Set selector lever in position "P".