Removing and Installing Conductor Strip

01M, 4 Spd. A/T

01 - On Board Diagnostic (OBD)





Fig. 5 Removing and installing conductor strip

Special tools
^ 3373 Lever

The conductor strip can be replaced with the transmission installed and without removing the valve body.

Note: Do not kink or damage the conductor strip.

Removing and installing conductor strip
- Separate connector at transmission and remove retaining clamp.
- Drain ATF.
- Remove transmission oil pan and remove wiring guide





- Pry conductor strip off solenoid valve in direction of arrow using special tool 3373.

Note:
^ If the locating points are damaged the valve body must be replaced.
^ Installation is performed in the reverse order of removal.
^ Do not kink or damage the conductor strip.