Window Regulator Switch Module, Driver Side

Window Regulator Switch Module, Driver Side

Special tools, testers and auxiliary items required

• Trim Removal Wedge (VAS 3409)

Window Regulator Switch Module - Driver Side, 4-door

• Left Front Window Regulator Switch (E40)

• Driver Left Rear Window Regulator Switch (E53)

• Driver Right Rear Window Regulator Switch (E55)

• Driver Right Front Window Regulator Switch (E81)

• Child Safety Button (E318)

• Push Button Illumination (L76)

Window Regulator Switch Module - Driver Side, 2-door

• Left Front Window Regulator Switch (E40)

• Driver Right Front Window Regulator Switch (E81)

• Push Button Illumination (L76)

The components listed above cannot be replaced separately. If faulty, the switch module must be replaced.


• Turn off the ignition and all electrical consumers.

• Remove the key.

• When removing and installing components in visible area (switches, covers, trim, etc.), cover by taping the areas at which a prying tool ( (VAS 3409) , screwdriver) will be positioned using commercially available adhesive tape.


Do NOT try to press or lift the front part of the installation frame (in the switch area) from the door trim. This damages the switch. Spread or raise the frame only from behind, as indicated by the - arrow -.

Removal

- Carefully pry the frame out of the door trim panel - arrow - using a (VAS 3409).






- Release and disconnect the harness connectors - arrows -.






- Open the tabs - arrows - and remove the switch module.






Installation

Install in reverse order of removal.