Rear Bumper, Sedan

Bumper Cover

• Before replacing bumper cover, explore possibility of repairing damage to plastic. Refer to

• Due to model variations, small deviations must be considered during removal and installation.

Removing

- Remove taillamp assembly in side panel on left and right..

- Remove screws - 7 - in area of left and right wheel housing liner.

- Pry out left and right expanding rivet - 3 - using a screwdriver.

- Remove bolts - 4 - and - 5 - from below.

- Remove bolts - 2 - from above.

- Remove bolt - 1 - on left and right of luggage compartment out (remove side luggage compartment cover.).

• A second technician is required for the rest of the removal procedure.

- With a second technician, pull bumper cover - 6 - parallel out of guide profiles.

- Disconnect harness connectors of installed electrical components.





Installing

Installation is performed in the reverse order of removal.

Make sure gaps are parallel and pay attention to gap dimensions.