Door

Door

Removing

- Release rubber boots- 6 - by pressing on locking mechanism - arrow a - and remove boots from B-pillar.

- Swivel locking lever - 7 - downward - arrow b - and disconnect electrical harness connector - 8 - from connector station.

- Remove bolts - 4 -, - 5 - and - 11 - using door adjustment wrench (3320) and bit insert (3320/3) from hinge.

- Pull door - 1 - in - direction of arrow - from guide bolts - 2 - and - 9 -.





Installing

Installation is performed in the reverse order of removal.

Tightening specification for bolts - 4 -, - 5 - and - 11 -: 20 Nm + 1/4 additional turn (90°)

Always replace bolts - 4 -, - 5 - and - 11 -.

Pay attention to rear door gap dimensions.