Sun Shade
Sun Shade
Removing
- Move the sun shade all the way into the open position.
• Using a hex socket head wrench, rotate shade motor into open direction to removal position if the electrical system malfunctions. Refer to => [ Operating without Electricity ] Operating without Electricity
- Remove the rear glass sunroof panel. Refer to => [ Rear Glass Panel ] Rear Glass Panel.
- Remove the screws - 3 - from the cap - 2 - (2 Nm).
- Unclip the cap retainer - arrow - - 2 - from the rear lid using a screw driver - 4 - and fold the cap - 2 - up.
Do not remove the inner seal - 1 -.
- Carefully lift the shade arch - 2 - together with the sun shade slide - 1 -.
• Be sure not to damage the shade material - 3 -.
- Pull the sun shade slide - 1 - to the side in the direction of the - arrow - out of the sun shade arch - 2 -.
- Remove the headlines..
- Remove the screws - 1 - for the shade cartridge - 2 - (3.5 Nm).
- Pull the sun shade cartridge - 2 - in the direction of the - arrow - slightly downward so that it can get past the sun shade motor - 3 -.
- Remove the sun shade cartridge - 2 - sun shade steel band - 4 - in the direction of the - arrow - from the sun shade rail - 1 -.
• Be sure not to damage the shade material - 3 -.
Removing the Sun Shade to Replace the Sun Shade Arch
- Carefully remove the sun shade arch - 1 - in the direction of the - arrow - from the weather strip - 3 - of the sun shade material - 2 -.
- Press the new sun shade arch - 1 - carefully on the weather strip - 3 -.
• Be sure not to damage the shade material - 2 -.
Installing
• The sun shade arch must be mounted prior to installing the sun shade cartridge.
• Do not lubricate the sun shade slide and cables.
- Push the sun shade cartridge - 2 - sun shade steel band - 4 - in the direction of the - arrow - on to the sun shade rail - 1 -.
• Be sure not to damage the shade material - 3 -.
Press the sun shade cartridge strap - 3 - - 2 - under the sun shade rail - 1 -.
- Press the sun shade slide - 1 - in the direction of the - arrow - into sun shade arch - 3 -.
• Make sure that the sun shade glide - 1 - latches into the cut-out in the sun shade steel band - 4 - and into the sun shade coupling plate - 2 -.
Further installation is in reverse order of removal.
Tightening specification:
Sun shade cartridge screw: 3.5 Nm
Cap screw: 2 Nm
• Check for ease of movement after installing the sun shade. Using a hex wrench, manually move the sun shade drive on the motor and make sure there are not creases or folds in the sun shade material.
- Install molded headliner.
- Install the rear glass sunroof panel. Refer to => [ Rear Glass Panel ] Rear Glass Panel
- After completing all the work, perform a sun shade motor adaptation. Refer to => [ Panorama Sunroof, Adapting ] Panorama Sunroof, Adapting.