Housing

Housing

Removing

- Pry off rear cover from rear door. Refer to=> [ Outer Door Panel ] Outer Door Panel - 2 -.

- Pry out cover cap in front of bolt - 1 -.





- Pull door handle - 2 - in - direction of arrow - and unscrew bolt - 1 - until it stops using socket wrench (T10072).

- Remove housing - 3 - at right angle to door from door handle bearing bracket.

Installing

- Insert the housing - 2 - at the right angle into the bearing bracket - arrow - on the door handle - 1 -.





Door handle - 1 - must make contact only lightly at door panel.

- Now install screw - 3 - into bearing bracket using socket wrench (T10072).

Door handle engages again into housing with a very audible click.

• During installation, housing must be pressed onto door panel. The door handle rests only lightly against the door panel.

Further installation is in reverse order of removal.

• Then a function test must be performed with door open, since the door cannot be opened if release is not correctly adjustment or clipped in.