Function

Function

All moving functions of sunroof with glass panel can be performed with ignition switched on.

After ignition is switched off, the movement functions can be performed until either the driver or front passenger door is opened.

The opening of glass panel for sliding and tilt position is pre-selected using the rotary switch.

On the rotary switch, there are markings for preset sliding and tilt positions of the glass panel.

Opening the sunroof in the so-called comfort position prevents most driving noise which may occur when open completely.

Switch for automatic preset





The sunroof with glass panel is equipped with a closing force limit. When an obstruction is met during the closing sequence from the lifting or sliding position, the roof opens again by itself.

In addition, there is an emergency close function. If there are problems closing, sunroof with glass panel can be forced closed by pressing the preselector, which must be located in the "sunroof closed" position.

For the emergency close function, the closing force limit is deactivated.

The drive motor for sunroof with glass panel is protected against overheating via a running time limit. The protective mechanism activates after an uninterrupted operation of approx. two minutes. It can only be operated again after a cool-off phase.

If current fails, sunroof with glass panel can be moved at drive motor using a hex wrench. Hex wrench is located in vehicle tool kit.