without Anti-Theft Protection

without Anti-Theft Protection

• If the Engine Control Module (ECM) will be replaced, connect the vehicle diagnostic tester and perform the "Replacing Engine Control Module" guided function.

Removing

- Turn off the ignition.

- Remove the wiper arms and plenum chamber cover.

- Remove the plenum chamber bulkhead.

- Disengage the front harness connector - 1 - and disconnect it from the ECM.






- Pry up the locking mechanism - 2 - slightly.

- Then, slide the ECM out of the retainer - arrow -.

- Now, disengage the rear harness connector and disconnect it from the ECM.

Installing

- Connect the rear harness connector to the ECM and engage it.

- Slide the ECM onto the retaining plate.

- Press the catch - 2 - against the ECM.






- Now, connect the front connector - 1 - to the ECM and engage it.

- Install the plenum chamber bulkhead.

- Install the wiper arms and plenum chamber cover.