Electrical & Electronic Components, Locations

Electrical & Electronic Components, Locations

CAUTION:
Before beginning repairs on the electrical system:
- Obtain the anti-theft radio security code.
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Disconnect negative (-) battery terminal.
- When disconnecting and reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified.





1 - Instrument cluster -K-
- Monitored by OBD
2 - Engine coolant temperature (ECT) sensor -G2-
- Location depends on type of engine
- Monitored by OBD
3 - Speedometer vehicle speed sensor (VSS) -G22-
- Location
4 - Sender for fuel gauge sender -G-
- Location
- Monitored by OBD
5 - Outside air temperature sensor -G17-
- Location
- Monitored by OBD






Fig. 5 Speedometer vehicle speed sensor (VSS) -G22-

The speedometer sensor -arrow- is located in the area of the left-hand drive shaft flange on manual and automatic gearbox vehicles.






Fig. 6 Sender for fuel gauge sender -G-

The sender for fuel gauge -G- is located in the fuel tank on the fuel delivery unit -arrow-.

To remove and install fuel delivery unit:






Fig. 7 Outside air temperature sensor -G17-

The outside air temperature sensor-G17- is located on left of front bumper behind the outer air grille.

Unclip air grille to remove sender.