Transmission Temperature Sensor/Switch: Service and Repair

Transmission Input Speed Sensor with Clutch Oil Temperature Sensor

Removing

• Both sensors are combined into one component and can only be replaced together. They are located in transmission in vicinity of clutch. Before removing, Direct Shift Gearbox (DSG) Mechatronic ( J743) must be removed.

CAUTION!
Do not pull on wire of connector! If wire is damaged, the Transmission Input Speed (RPM) Sensor ( G182) with Clutch Oil Temperature Sensor (G509) must be replaced.

- Remove Direct Shift Gearbox (DSG) Mechatronic ( J743 ) => [ Direct Shift Gearbox Mechatronic ] Direct Shift Gearbox Mechatronic.

Do not pull on wire!

- Remove bolt - B - and carefully pry out sensor - A - using a screwdriver and/or pliers.





- Carefully disconnect connector - C -.

Installing

Re-install Transmission Input Speed (RPM) Sensor ( G182 ) with Clutch Oil Temperature Sensor (G509 ) only if it is certainly known:

• Sensor functions properly.

• Its wire was not pulled during removal.

- If necessary, clean bore for Transmission Input Speed (RPM) Sensor (G182) with Clutch Oil Temperature Sensor (G509) of sealant residue.

- Coat new Transmission Input Speed (RPM) Sensor ( G182) with Clutch Oil Temperature Sensor (G509 ) - A - with direct shift transmission oil and guide sideways into opening on transmission housing.





- Install new bolt - B - and tighten to 10 Nm.

- Install Direct Shift Gearbox (DSG) Mechatronic ( J743 ) => [ Direct Shift Gearbox Mechatronic ] Direct Shift Gearbox Mechatronic.