Automatic Rollover Protection

Automatic Rollover Protection, Convertible

=> [ Automatic Rollover Protection ]

=> [ Impact Bar ]

Automatic Rollover Protection





Removal

- Open the convertible top.

- Raise automatic rollover protection.

- Disconnect the battery ground connection.

- Remove the backrest.

- Disconnect connection - 5 - from the solenoid switch (driver rollover protection solenoid ' (N309)/' front passenger rollover protection solenoid (N310))

- Remove the automatic rollover protection trim.

- Remove bolts - 1 -.

- Pull the automatic rollover protection out and up.

Installation





- Insert the automatic rollover protection into the opening from above.

- Thread in bolts - 1 - (29 Nm).

- Install the automatic rollover protection trim.

- Press the automatic rollover protection down. Refer to => [ Lowering Automatic Rollover Protection ] Automatic Rollover Protection, Convertible

- Reconnect connection - 5 - to the solenoid switch (driver rollover protection solenoid ' (N309)/front passenger rollover protection solenoid ' (N310))

- Install the backrest.

- Connect the battery ground connection.

CAUTION!
No one should be in the vehicle.

• After connecting the battery, the vehicle options (radio, clock, electric window regulator) must be checked according to the repair information and/or user manual.





Impact Bar

- Open the convertible top.

- Raise the automatic rollover protection.

- Remove expanding rivet - 2 -.





- Remove impact bar - 1 -.