ATF Level, Checking

ATF Level, Checking





- Switch off engine.





The ATF temperature should not be more than approximately 30°C at start of test.
^ Transmission not in emergency running mode; ATF temperature not above approximately 30°C
^ Vehicle must be standing level
^ Selector lever in "P".
- Connect tester and continue switching until it is ready for operation Vehicle Diagnosis, Testing and Information System VAS 5051, Connecting and Selecting Functions.
- Press right Guided Functions.
- Then select vehicle, the transmission and Check ATF Level.
- Press ->.
- Start engine.
- Raise vehicle.
- Place drip tray under transmission.
- Press.

If a test temperature between 35°C and 45°C is displayed:





- Remove ATF inspection plug from oil pan.





The ATF present in the overflow tube runs out.

If ATF drips out of drilling:

ATF does not need topping off.
- Install new seal to plug and tighten to 15 Nm. This completes the ATF check.

If no ATF drips out of inspection hole:
- Top off ATF Topping Off ATF.