Passenger Airbag Unit

Airbag

Passenger Airbag Unit

Removal

CAUTION!
• Read the Safety Instructions for working with airbags, belt tensioners and battery cut-out units.

• Note the special instructions for the driver and passenger airbags.

- Disconnect vehicle battery.

- Remove the glove compartment. Refer to => [ Glove Compartment ] Storage Compartments, Covers and Trim

CAUTION!
Electrostatic discharges can lead to an unintended deployment of the airbag. Therefore the technician must discharge static electricity from the body before separating the ignition and ground wiring. This is done, for example, by briefly touching the body or the door striker or pin.

- Disconnect wiring harness from front passenger side airbag.

- Remove the two bolts - 1 -.

- Remove the two bolts - 2 -.

- Remove passenger airbag from mount in instrument panel.





Installation

- To install, perform the steps used for removal in reverse order.

• Screws - 1 - and - 2 - are to be inserted with locking compound D 197 300 A1.

• Tightening specification for screws is 8 Nm.





- Switch on ignition.

CAUTION!
Make sure that no persons are in the vehicle.

- Connect vehicle battery.