Footwell Lamps

Instrument Panel Lamps and Switches

Footwell Lamps

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

• Left Footwell Lamp (W9)

• Right Footwell Lamp (W10)

• The foot well lights are located in trim beneath instrument cluster.

• When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool ((3409), screwdriver) will be positioned, using commercially available adhesive tape.

• Removing and installation is the same for all footwell lights and is described here for only one light.

Removing:

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

- Carefully pry out footwell lights using (3409) or a screwdriver.





- Disengage harness connector and disconnect it.

Bulb, Replacing:

- Disengage retaining tabs - 1 - and remove heat shield - 2 - from diffusion lens of foot well light.





- Carefully pry bulb from socket.





- Replace the glass base bulb (12V, 5 W).

Installing:

Install in reverse order of removal.