Coolant FC (Fan Control) Control Module, Checking

Coolant FC (Fan Control) Control Module, Checking

NOTE: Coolant Fan Control (FC) Control Module -J293- and Coolant Fan -V7- are one component and cannot be replaced individually.

Recommended special tools and equipment
- V.A.G 1526 multimeter or V.A.G 1715 multimeter
- V.A.G 1594 connector test kit
- Wiring diagram

Test requirements







- Corresponding main fuses on E-box in engine compartment, left side, for Coolant Fan Control (FC) Control Module -J293- must be OK.

NOTE: Fuses on this fuse holder are labelled "SA" in the wiring diagram.

- Battery voltage must be at least 11.5 Volts.
- All electrical consumers such as, for example, lights and rear window defroster must be switched off.
- Ground (GND) connections between engine and chassis must be OK.
- Coolant Fan -V7- moves easily and is not blocked by a foreign body.
- Ignition switched off.

Test sequence
Observe safety precautions.
Observe rules for cleanliness.







- Disconnect 4-pin harness connector -2- from Coolant Fan Control (FC) Control Module - J293-.

Checking voltage supply







- Connect multimeter for voltage measurement with adapter cables to
Terminals 1 and 4
Terminals 2 and 4 of connector

- Switch ignition on.

Specified value: at least 11.5 V

- Switch ignition off.

If there is a malfunction in voltage supply:







- Check wires between 4-pin connector (terminals 1 and 2) and corresponding fuse holder for open circuit according to wiring diagram.

Wire resistance: max. 3.0 ohms

- Check for open circuit in wire between 4-pin connector terminal 4 and Ground (GND) according to wiring diagram.

Wire resistance: max. 3.0 ohms

- Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. Diagnostic Mode 04 - Erase DTC Memory
- Generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes

If there is no malfunction in voltage supply:
- Check wire to Engine Control Module (ECM) according to wiring diagram.

Checking wire to Engine Control Module (ECM)
- Connect test box to 94-pin connector of wiring harness, connecting test box for wiring test. Test Box, Connecting For Wiring Test

Engine Control Module (ECM) is not connected.







- Check wire between test box and 4-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
Terminal 3 + socket 28

Wire resistance: max. 3.0 ohms

- Also check the wire for short circuit to B+ and to Ground (GND).

Specified value: infinity ohms

- Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. Diagnostic Mode 04 - Erase DTC Memory
- Generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes

If no malfunctions are found in wire:
- Replace Coolant Fan -V7- with Coolant Fan Control (FC) Control Module -J293-.
- Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. Diagnostic Mode 04 - Erase DTC Memory
- Generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes