Backrest Covers and Upholstery

Rear Seat Covers and Upholstery

Backrest Covers and Upholstery

• Removal and installation of components is described for right backrest. The same instructions apply for removal and installation of components for left backrest.

Removal

Only vehicles with pass-through

- Remove storage unit with center armrest. Refer to => [ Pass-Through Unit with Center Armrest ] Pass-Through Unit With Center Armrest

All vehicles

- Remove seat bench. Refer to => [ Bench Seat ] Rear Seats.

- Remove backrest. Refer to => [ Backrest ] Rear Seats

- Press corresponding button in headrest guide and pull headrest - 1 - out of backrest.

- Press side locking mechanisms - arrows - and release belt extraction panel - 2 - from mounts.

• Belt extraction panel - 2 - has a one-time locking mechanism and therefore must be replaced when installing.

- Press side locking mechanisms inward and pull cover - 3 - out of backrest.

- Using a screwdriver, pry all profiles - 4 - out of mounts - 5 - on rear side of backrest along the circumference.





- Roll up cover on the sides.

- Release the catches on the bottom of the head restraint guides and remove them from the backrest.

- Using a small screwdriver, press apart side ribs of mounts - 1 - and pull out grip channels - 2 -.

- Release cover - 3 - and upholstery - 4 - from backrest frame - 5 -.





Installation

- To install, perform the steps used for removal in reverse order.