Tail Lamp: Adjustments

Tail Lamps, Adjusting

• On vehicles from 11.05, an adjustment element is installed which can be used to adjust the flush dimension to the bumper cover. On vehicles before 11.05, this adjustment is not possible.

- If the taillamp does not sit flush as shown in the illustration, it can be adjusted with the adjusting element. An adjustment of +/- 2 mm is possible.





- Press side trim - 1 - to side in - direction of arrow -.





- Loosen nuts - 1 - on taillamp in side panel.





- Rotate the adjusting element - arrow - in the corresponding direction until the flush dimension between the tail lamp and bumper cover is correct.





- Tighten the mounting nuts - 1 - to the specification. Refer to=> [ Fastener Tightening Specifications ] Fastener Tightening Specifications.