Side Pane Tail Lamps

Tail lamps

Side Pane Tail Lamps

Removing

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Press side trim - 1 - to side in - direction of arrow -.





- Remove connector - 2 - by pressing clip - 1 - in - direction of arrow -.





- Remove mounting nuts - 1 - at taillamp assembly in side panel.





- Remove taillamp assembly.

Installing

Install in reverse order of removal, noting the following:

- Tighten the mounting nuts - 1 - to the specification. Refer to=> [ Specifications ] Specifications.





• Taillamp assembly harness connector must engage "audibly" in side panel when connecting.

- Check the gap dimension to the body after installing the tail lamp assembly.

- On vehicles from 11.05, adjust the flush dimension to the bumper cover if necessary. Refer to=> [ Tail Lamps, Adjusting ] Adjustments.

- On vehicles through 11.05, the flush dimension to the bumper cover cannot be adjusted.