Operation CHARM: Car repair manuals for everyone.

Engine Installing






Engine, Installing

CAUTION!
When doing any repair work, especially in the engine compartment, pay attention to the following due to clearance issues:

Route lines of all types (e.g. for fuel, hydraulic, additive, coolant and refrigerant, brake fluid, vacuum) and electrical wiring so that the original path is followed.

To prevent damages to the lines, make sure there is sufficient clearance to all moving or hot components.

Installation is performed in reverse order. When doing this note the following:

- Make sure centering sleeves for engine to transmission are installed in cylinder block. Install if necessary.

- Reconnect all lines, hoses and connections that were disconnected for the removal sequence.

- Electrical connections and routing.

- Connect Air Conditioning (A/C) lines.

- Top off oil level for power steering system.

- Fill the cooling system. Refer to --> [ Cooling System, Draining and Filling ] [1][2][3]Cooling System, Draining and Filling.

- Check headlight adjustment, correct if necessary.

- Perform test drive and check all Diagnostic Trouble Code (DTC) memories. Refer to VAS 5052 "Guided Fault Finding".

Tightening Specifications