Front Airbag Crash Sensors

Front Airbag Crash Sensors

• Removal and installation is described for the right-hand side of the vehicle. Removal and installation for the left-hand side is performed in the same manner.

Removing

CAUTION!
Observe safety precautions for working on airbags --> [ Airbag Safety Precautions ] Technician Safety Information.

- Disconnect batteries.

- Remove front bumper

- Remove two nuts - 1 - (9 Nm).

- Disconnect the wiring harness - 3 - from the crash sensor - 2 -.





Installing

- Perform the steps used for removal in reverse order.

- Switch the ignition on.

CAUTION!
Make sure that no persons are in the vehicle.

- Connect battery ground (GND) strap --> Electrical Equipment 27 Removal and Installation