Engine Code BAR

Starter

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331/)

• Torque Wrench (V.A.G 1332/)

• Shop crane (VAS 6100)

• Lifting tackle (2024 A)

Removing

- Remove the engine --> Engine Mechanical, Fuel Injection and Ignition 10 Removal and Installation.

- Remove nut - arrow - from engine mount.





- Remove screws - arrows -.





- Engage Lifting Tackle (2024 A) in lifting eyes on cylinder heads.





- Hook the lifting tackle (2024 A) into the shop crane (VAS 6100).

- Lift the engine with the shop crane (VAS 6100).

- Remove engine mount.

- Remove three bolts for engine mount bracket at engine block.

- Move engine bracket slightly to side.

• Engine bracket must not be removed completely. Ground lines remain connected.

- Remove upper starter bolt - arrow - on transmission side.

- Remove heat shield - 2 - from wiring retainer.





- Remove the lower bolt for the starter - arrow - on the engine side.





- Remove starter from transmission housing, being careful of wires.

- Disconnect electrical connection - 1 -.

- Remove protective cap - 2 - and nut beneath.





- Remove starter.

Installing

Install in reverse order of removal, noting the following:

- Tighten the fasteners to the specification --> [ Starter ] [1][2]Specifications.