HID Headlamp Control Module

HID Headlamps with Cornering Lamp, from 12.06

HID Headlamp Control Module

• Left High-intensity Gas Discharge Lamp Control Module (J343) and Right High-intensity Gas Discharge Lamp Control Module (J344) is not capable of On Board Diagnostic (OBD).

• Illustrations depict replacement of High-intensity Gas Discharge Lamp Control Module at left headlamp.

• Replacement of Left High-intensity Gas Discharge Lamp Control Module (J343) and of Right High-intensity Gas Discharge Lamp Control Module (J344) is performed analogously.

Removing

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove headlamp --> [ HID Headlamps ]. HID Headlamps

- Remove both mounting bolts - arrows - and remove HID headlamp control module - 1 - straight out of headlamp housing.





• The HID headlamp control module electrical connector is disconnected at the same time it is removed from the headlamps housing.

Installing

Install in reverse order of removal, noting the following:

• Make sure seals have proper seating when installing High-intensity Gas Discharge Lamp Control Module. It is destroyed by ingress of water into headlamp.

- Check headlamp for function.

- Check and adjust headlamp aim if necessary.