Headlamp Range Control Positioning Motor

HID Headlamps, through 11.06


Headlamp Range Control Positioning Motor

• If adjusting motors for headlamps with automatic vertical headlamp aim control are removed and installed or replaced, basic setting of headlamps must be performed .

• Illustrations depict replacement of headlamp beam adjusting motor at left headlamp.

• Replacement of Left Headlamp Beam Adjustment Motor (V48) and of Right Headlamp Beam Adjustment Motor (V49) is performed analogously.

Removing

- Remove headlamp --> [ Headlamps, through 11.06 ] Headlamps, through 11.06.

- Remove bolt - 1 - and press adjusting shaft for low beam and high beam height adjustment - 2 - in - direction of arrow - out of guide.





- Pull adjusting shaft for low beam and high beam height adjustment - 2 - out of headlamp housing.

- Press wire bracket - 1 - to the side in - direction of arrow - and remove cover cap - 2 -.





- Disconnect connector - 3 -.





- Remove mounting bolts - 1 -.

- Press the headlamp beam adjusting motor - 2 - toward left in order to pull out adjusting axle ball head laterally out of ball head mount at reflector.

- Remove headlamp beam adjusting motor - 2 - out of headlamp housing.

Installing

Install in reverse order of removal, noting the following:

• When installing cap, ensure proper seating. It is destroyed by ingress of water into headlamp.

• If adjusting motors for headlamps with automatic vertical headlamp aim control are removed and installed or replaced, basic setting of headlamps must be performed .

- Insert adjusting axle of headlamp beam adjustment motor - 1 - carefully into ball head guide - arrow -.





- Check headlamp for function.

- Check and adjust headlamp aim if necessary.